If no SDM files were displayed when you issued the show flash command in Task 1, SDM is not installed on your router and you must obtain it from. Task 2: Download and Install the Latest Version of SDM SDM only supports Cisco IOS images of version 12.2(13)ZH or later. Step 2 To determine if CRWS software is present, issue the following CLI command: Step 1 Access the router command-line interface (CLI), using either Telnet or the console connection. Beginning on September 27, 2004, all Cisco 83x routers shipped with either SDM in flash or CRWS in webflash, depending on whether SDM or CRWS was ordered.ĭetermine which software is installed in router memory by completing the following procedure: The CRWS image are stored in webflash memory and the SDM image are stored in flash memory.

Task 1: Determine Which Software is Installed on the RouterĬisco 831, 836, and 837 routers manufactured after the date that SDM became available may have both SDM and CRWS pre-installed. Task 2: Download and Install the Latest Version of SDM.Task 1: Determine Which Software is Installed on the Router.This document contains the following sections: Therefore, it is recommended that you save a copy of your existing router configuration file before performing the switch-over procedure. Note The switch-over procedures in this document will replace the current router configuration file with a new configuration file for the new device manager.

Cisco router web setup tool software